How to print Y-BOX? Part 2
If you have printed all parts from “How to print Y-BOX Part 1” you have 80% of the print job done. Here the rest follows.
Corner covers
- BY07V01 – upper corner cover
- BY02V01 – upper corner cover with a hole (alternative to BY07V01)
- BY08V01 – bottom corner cover with an opening for base attachment pin
Vertical shells perimeters: 2 recommended
Infill density: 25%
Infill pattern: Grid
Support material: no
Layer height: 200 µm
Skirt: standard
Brim width: 0 (zero)
Material: PLA, ABS, PET
Hinges and Flat Joints
BY22V01 – door hinge
BY23V01 – frame hinge
BY24V01 – flat joint
These parts are more mechanically stressed therefore it is recommended to make it stronger with 3 shell perimeters and 30% infill.
Vertical shells perimeters: 3
Infill density: 30%
Infill pattern: Grid
Support material: yes
Support only from the base plate: checked (if this remains unchecked, the slicer will generate supports also in the holes)
Layer height: 200 µm
Skirt: standard
Brim width: standard
Material: PLA, PET, ABS
The Mechanical Lock
BY26V02A – latch
BY26V02B – door stop
BY26V02C – door handle, knob
Vertical shells perimeters: 2 recommended
Infill density: 25%
Infill pattern: Grid
Support material: no
Layer height: 200 µm
Skirt: standard
Brim width: standard
Material: PLA, PET, ABS
Leave a Reply
You must be logged in to post a comment.