ATTENTION: if you downloaded models before May 17th 2020, please download again new version of Etui_v2.stl. Finally, for the swatches I have finished design for an étui, (may be better to say a frame, but I like the word étui) to hold the filament swatches together. The first version had thinner walls and was very fragile. I ended up with 5 mm. It holds 10 swatches and there is again, a place for a label of size 38.1 mm x 21.2mm....
If you have printed all parts from "How to print Y-BOX Part 1" you have 80% of the print job done. Here the rest follows. BY07V01 - upper corner cover BY02V01 - upper corner cover with a hole (alternative to BY07V01) BY08V01 - bottom corner cover with an opening for base attachment pin Vertical shells perimeters: 2 recommended Infill density: 25% Infill pattern: Grid Support material: no Layer height: 200 µm Skirt: standard Brim width: 0 (zero) Material: PLA, ABS, PET BY22V01 - door hinge BY23V01 - frame hinge BY24V01 - flat joint These parts are more mechanically stressed therefore...
